The cause of common problems in drinking water filling machine zui

First, the filling is not full

1. The valve is inactive, stuck, and the water valve is not open;

2. The small hole in the return pipe is not properly ventilated by the water seal bottle;

3. The rubber at the contact between the valve port and the bottle is damaged, and the underwater flow is not smooth.

exclude:

1. Open the valve to check the spring and water valve rubber ring;

2. Is there a water-diving cap on the air return pipe? Check it and adjust it up and down.

3. Replace the sealing rubber.

Second, when the bottle leaves the valve mouth, the slurry

1. The valve is not closed. This is the main reason. If the valve is not dead, it will jet and spray when there is no bottle;

2. The "O" type seal ring in the gas valve is damaged, so that the valve is not closed;

3. The deflation position is incorrect;

4. Process problems.

exclude:

1. The friction between the fork pressing block and the fork of the cylinder is too small, the valve has rebound, and the rear closing position is pressed upwards to increase the friction to overcome the rebound;

2. Change the rubber band, pay attention to the 'O' circle is very critical, should be soft and flexible;

3. When the filling is full, deflate, and the excess gas in the bottle should be removed from the bottom of the bottle to the bottle mouth;

4. Adjust the beverage process.

Third, the deflation valve leakage is insufficient

1. “0” type seal ring is damaged;

2. Reset spring deformation.

exclude:

1. Replace the "O" ring;

2. Replace the spring.

Fourth, the machine is not stable during operation

1. Spring box shaft wear key and shaft clip;

2. The roller is off or the bearing is worn;

3. Drive large worm gear wear;

4. Motor failure.

exclude:

1. Check the spring box;

2. Replace the bearing and the roller;

3. Check and remove the worm gear;

4. Check the motor.