Do you know the product advantages of sodium gluconate dryer?

Sodium gluconate dryer, also known as fluidized bed, has been used for more than 30 years. It is now more and more important in pharmaceutical, chemical, food and food processing. It is composed of air filter, bubbling bed host, cyclone separator, bag filter, high pressure centrifugal fan and operation console. Due to the different nature of the dry materials, when the dust removal equipment is matched, it can be carried out as needed. At the same time, the cyclone separator and the bag filter can be selected. You can also choose one of them. In general, a material with a large specific gravity only needs to select a cyclone separator. Materials with a lighter weight need to be equipped with a bag filter and a pneumatic feeder is available. The sodium gluconate dryer has two modes of operation, continuous type and gap type.

How does the sodium gluconate dryer work?

The clean hot air is distributed into the bed through the valve plate, and the wet material entering from the feeder is boiled by the hot air. Due to the extensive contact between hot air and materials, the process of heat and mass transfer is increased, so it can be dried in a short time. If the continuous type is used, the material enters from one end of the bed, and after boiling for several tens of seconds to several minutes, it automatically flows out from the other end of the bed. This equipment is generally operated under negative pressure.

Sodium gluconate dryer product use

Drying of pharmaceuticals, chemical raw materials, food, grain processing, and feed. Such as: drying and dehumidification of raw materials, tablet granules, traditional Chinese medicine granules, health food, beverage granules, corn germ, feed, plastic resin, citric acid and other granular materials. Applicable materials generally have a particle size of 0.1-6 mm and a particle size of 0.5-3 mm.

Sodium gluconate dryer advantages described

1. The equipment adopts the form of segmented air inlet, and the drying section and cooling section are designed. In the drying section, the design of high air volume and stroke pressure of 110-120 °C is adopted, so that the viscous wet granular material is quickly dispersed and the surface is pre-baked, and the fluidized bed inlet is prevented from being excessive due to the positive pressure. Spraying phenomenon

2. The uniform air plate of the fluidized bed adopts a combined structure. The tongue-shaped hole structure adopts a tongue-shaped hole structure with uniform wind direction and small pressure drop, which accelerates the material advance speed to prevent material from accumulating at the feed inlet. The middle and rear section plates adopt straight hole type. The bed board prolongs the residence time of the material in the fluidized bed and improves the drying effect.

3. The upper bed is designed with a circular arc shape and is strengthened by stainless steel flange. The appearance is beautiful and easy to clean without sanitary corners, and the fluidized area is increased to improve the drying and cooling effect.

4. Drying system damping is imported from Germany. The airbag shock absorber is good. The vibration damping effect is good. The equipment runs smoothly and the running noise is low. It can make the equipment quickly cross the resonance zone during the process of starting and stopping, avoiding the phenomenon of “resonance” between the equipment and the plant.