Warming measures for winter finishing pig houses

In winter, when the temperature is low, pigs are forced to use the body's fat in order to resist severe cold, resulting in slower weight gain and lower feed utilization. It also causes the body's resistance to disease to decline, and it is prone to disease, which seriously affects the breeding efficiency. Therefore, it is very important to do a good job of keeping cold insulation in finishing pig houses in winter. Usually, the following measures can be selected:

Anti-thief wind. In winter, cold winds intrude into pig houses. Attacks on pigs can cause pigs' colds and other diseases. Therefore, the places where the pig houses leak are blocked before winter and cold winds are prevented from entering.

Pad hay. When piglets are transferred from nursery houses to finishing houses or new piglets are purchased, some straws, soft straws, etc. shall be added to the finishing houses to reduce the stress response caused by changes in the temperature of the transitional groups, and moisture absorption and moisture removal may be performed. Absorb harmful gas and other effects. Pay attention to changing the ground, avoid moisture, mildew rotten produce ammonia, harm the health of pigs.

Appropriate increase in stocking density. In winter, the temperature is relatively low and the stocking density can be appropriately increased. Generally, the stocking density is increased by about 30% compared with the summer season. Increased calories in pigs can increase the temperature, while the pigs sleep close to each other and can both warm each other and increase the overall temperature in the pig house.

Add energy feed. When formulating a pig's diet, the ratio of vegetable oil, corn and other energy feeds should be appropriately increased, and warm water should be consumed. And appropriate amount of vitamins, amino acids, etc. that have anti-stress and anti-oxidant abilities. The feed supply is adequate, the number of feedings is increased during the day, and the pig food must be dried in order to enhance the resistance to cold and disease, and to promote rapid weight gain.

Keep pigsty dry. In order to prevent pig house from dampness, we should do the following: First, prevent leakage and snow leakage; Second, we must constantly change the bedding; Third, we must timely clean the pig manure, using dry excrement method; Fourth, make the pig house ground outside the surface When the humidity of the piggery is relatively large, moisture can be absorbed by adsorbents such as grass ash, coal ash slag, quick lime, and charcoal.

Pay attention to ventilation in the pig house. Keep the ventilation of the piggery at the same time. If the concentration of harmful gases in the pig house is too high, the ability of the pig to resist disease and keep cold will be significantly reduced. Therefore, every day at noon to open the doors and windows ventilation, remove harmful gases, exchange fresh air in order to facilitate the growth of pigs.

High Resolution Distance Sensor

JRT produced the high resolution optical distance measurement sensor for 16 years with lower cost. Our distance measuring sensor have small size, high accuracy.
The laser range finder components is characterized by an above-average measured value output frequency, up to 8hz. The miniature laser distance module is also suitable for monitoring defined distance and height during transport.

Distance Measuring Sensor,Accurate Laser Measuring Sensor,High Accuracy Distance Sensor ,Optical Distance Sensors

Chengdu JRT Meter Technology Co., Ltd , https://www.rangingsensor.com