Why does the ZP type tablet press mold have cracks?

ZP type tablet press mold has been peeled off after being pushed out in the die hole. It refers to the split piece . Why is the split piece mostly caused by too much fine powder in the particle? When there is air in the particle during compression, the speed is faster when compressed. The gap between the punch and the die hole is relatively small. The air is not removed from the particles during compression, and is enclosed in the sheet. When there is no pressure, the air expands, which causes the split.
According to the above situation, we should first make the fine powder in the granules a pre-pressing device, so that the air may escape. However, many cases are unexplained. When the pressure is relatively high, the lobes will occur. When the pressure is reduced, the pressure can be prevented. If the particles are too dry, cleavage will occur, so the water content also plays a key role. . The reason for the die splitting of the ZP type tablet press is that the compression behavior of the particles is not good, the elasticity of the particles is relatively strong, and the elasticity of the pressed tablet is relatively high, and the unevenness of the pressure is also caused.
With the rapid development of computer high-tech such as network, broadband network and virtual, equipment remote monitoring and remote diagnosis technology are also emerging. Computer-controlled tablet presses are beginning to be widely used in pharmaceutical companies, enabling remote monitoring and remote diagnostics to be used in the tablet press industry. At present, remote monitoring and remote diagnosis functions are commonly available on ZP-type tablet press molds advanced in developed countries. The establishment of such a system is also to realize the network dialogue between the technology center (servant) and the tablet press user (user) through the Internet, so that the service party can understand the fault of the user tablet machine through the Internet in different places, and the ZP type pressure The die of the film machine executes the working state of the command, and then judges the failure of the tablet press and proposes a feasible solution.
Through the establishment of ZP type tablet press mold remote monitoring and remote diagnosis system, faults can be eliminated in real time, greatly improving the after-sales service response capability and speed of the tablet press manufacturer, and also improving the economic benefits of the enterprise. ZP type tablet press mold remote monitoring and remote diagnosis system should include personnel equipment, network construction, hardware facilities, software selection, etc., to complete the fault monitoring, analysis, feedback, release and real-time solution services, Ensure the effective operation of the entire system.

Slide Storage Boxes

Yancheng Rongtai Labware Co.,Ltd , https://www.shtestlab.com